CARBON AIR FLOW KIT BY VHM
Designed for optimum airflow using genuine carbon. Our carbon inlet prevents the airbox from deforming and greatly improves performance.
This inlet can be installed in the filter housing without any additional mounting or sealing parts
.
Make sure you place the inlet of the intake on the right side and make sure you hear a click when you push the intake down into the airbox rubber. Then it will fit perfectly!
Installing the intake
1. Remove the air cleaner cover
2. First you need to disassemble the temperature sensor
3. Hold the intake in one hand with the aluminum label facing
you.The hole for the temperature sensor should be facing down. This intake only requires a slight amount of pressure to fit it into the airbox rubber.
4. Make sure the intake fits snugly through the end and is not canted
.
The hole for the temperature sensor should match the hole in the rubber.
5. Install the temperature sensor, it goes through the airbox rubber and the inlet.
6. Install the air filter support and the air filter cover to ride.
7. Need to clean your bike? You can install an air box cover to make it waterproof
-
Real carbon
-Improve ground performance
-Optimal airflow
-Easy to install
-Prevents deformation of airbox rubber at high temperature
-Includes hole for temperature sensor
Click here for installation instructions ------->
Fits for: KTM SX-F250 2019 2022 KTM SX-F350 2019 2022 HUSQVARNA FC250 2019 2022 HUSQVARNA FC350 2019 2022 GASGAS MC250F 2021 2022